By Paul Homewood
I came across this analysis on the AWEO website, who campaign against wind power.
Energy consumption in wind facilities
Large wind turbines require a large amount of energy to operate. Other electricity plants generally use their own electricity, and the difference between the amount they generate and the amount delivered to the grid is readily determined. Wind plants, however, use electricity from the grid, which does not appear to be accounted for in their output figures. At the facility in Searsburg, Vermont, for example, it is apparently not even metered and is completely unknown [click here].* The manufacturers of large turbines — for example, Vestas, GE, and NEG Micon — do not include electricity consumption in the specifications they provide.
Among the wind turbine functions that use electricity are the following:†
- yaw mechanism (to keep the blade assembly perpendicular to the wind; also to untwist the electrical cables in the tower when necessary) — the nacelle (turbine housing) and blades together weigh 92 tons on a GE 1.5-MW turbine
- blade-pitch control (to keep the rotors spinning at a regular rate)
- lights, controllers, communication, sensors, metering, data collection, etc.
- heating the blades — this may require 10%-20% of the turbine’s nominal (rated) power
- heating and dehumidifying the nacelle — according to Danish manufacturer Vestas, "power consumption for heating and dehumidification of the nacelle must be expected during periods with increased humidity, low temperatures and low wind speeds"
- oil heater, pump, cooler, and filtering system in gearbox
- hydraulic brake (to lock the blades in very high wind)
- thyristors (to graduate the connection and disconnection between generator and grid) — 1%-2% of the energy passing through is lost
- magnetizing the stator — the induction generators used in most large grid-connected turbines require a "large" amount of continuous electricity from the grid to actively power the magnetic coils around the asynchronous "cage rotor" that encloses the generator shaft; at the rated wind speeds, it helps keep the rotor speed constant, and as the wind starts blowing it helps start the rotor turning (see next item); in the rated wind speeds, the stator may use power equal to 10% of the turbine’s rated capacity, in slower winds possibly much more
- using the generator as a motor (to help the blades start to turn when the wind speed is low or, as many suspect, to maintain the illusion that the facility is producing electricity when it is not,‡ particularly during important site tours or noise testing (keeping the blades feathered, ie, quiet)) — it seems possible that the grid-magnetized stator must work to help keep the 40-ton blade assembly spinning, along with the gears that increase the blade rpm some 50 times for the generator, not just at cut-in (or for show in even less wind) but at least some of the way up towards the full rated wind speed; it may also be spinning the blades and rotor shaft to prevent warping when there is no wind§
Could it be that at times each turbine consumes more than 50% of its rated capacity in its own operation?! If so, the plant as a whole — which may produce only 25% of its rated capacity annually — would be using (for free!) twice as much electricity as it produces and sells. An unlikely situation perhaps, but the industry doesn’t publicize any data that proves otherwise; incoming power is apparently not normally recorded.
Full post here.
It is a moot point just how much electricity wind turbines consume, but it is clearly some.
As such, the amount of wind power produced are effectively being overstated by official figures, if this own consumption is not taken into account. This is especially relevant when wind turbines are consuming electricity when the blades are not turning.
It also raises the questions of subsidies, which are paid to wind farms based on gross output. Surely these should only be payable for net output?
via NOT A LOT OF PEOPLE KNOW THAT
August 2, 2019 at 08:57AM
Iowa Climate Science Education 